Peugeot 308 Key Fob Replacement
Peugeot's 308 may be slightly old but it's still attractive. It's not the plushest car in its class and it's a Ford Focus or Volkswagen Golf will help you stay away from imperfections on the road - but it's a relaxed and pleasant driving experience.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If the issue is intermittent or constant the following suggestions should aid.
Water Damage
If you accidentally drop your key fob into an eddy, or it is soaked while kayaking, canoeing, rafting, or canyoning the fob is more likely to be damaged by water. The best way to avoid this from happening is to keep it in a dry bag when you're going outdoors or doing activities that require the fob to be exposed to high levels of water.
It is also important to ensure that the fob is completely dry prior to opening it and using it again. If you detect any smells emanating from the fob like an industrial liquid smell or windshield washer fluid, this is another indication that it's submerged in water.
A circuit board that is wet could cause the battery to dump its charge or even explode. If you can pull your keyfob 308 from the water and turn it upside up and shake as much water out as you can before opening the casing. After you open it, remove the battery and wipe down the circuit board using an abrasive soaked in 90 percent isopropyl alcohol.
Other causes why your Peugeot 308 remote entry keyless system may not work include a dead coin-cell battery or receiver module issues signal interference, or a defective chip. If none of these causes the cause, you can try resetting your system by disconnecting the battery with 12 volts for about 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with remote start technology that allows drivers to start their car from some distance, which allows them to warm up or cool down the car prior to entering. This feature is extremely helpful, especially during cold winter months. Remote start systems may be stopped for a variety of reasons, including the dead battery in the coin-battery.
The coin-shaped battery located inside the key fob can last between two and four months, depending on how often it is used, where it was purchased and how it is utilized. The date of use is displayed on the packaging or in the user's manual.
If the key fob has stopped working after exposure to pure tapwater, you need to remove the battery and clean the electronic chip using an absorbent paper towel that has been soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing. If the key fob has been exposed to salty or soapy water, it may have caused the chip to be damaged. It is necessary to replace it.
If you're not certain the battery is defective it is possible to test its voltage using an instrument set to the car's voltage range, and connect it to the terminals for minus and plus. If the voltage is lower than 12-13 volts, it is time to replace the battery. Alternately, you could attempt to reset the onboard computer by disconnecting the battery at 12 volts for a short period of time, and then reconnecting it in reverse order (positive cable first and then negative). The engine should be able to start after this.
Faulty Receiver Module
If you don't see the "Key Detected" It could be the receiver module malfunctioning. It's the component that sends out an alert when the key fob is activated. It also acts as an alarm that stops the vehicle from starting without the correct key.
It could be due to many factors, including water damage or just ageing. If the electronic chip within your Peugeot 308 keyfob is damaged by dirty tap water It could be because the keyfob was in contact with it. In this case you will have to take it off and thoroughly clean it using isopropyl or an electronic cleaner. When peugeot 107 key G28 Car Keys is dry then you can try again.
If the issue continues to persist, it is recommended to consult an area Peugeot expert or locksmith. They can use a diagnostic tool in order to pinpoint the problem and then fix it.
It is stressful to lose your Peugeot car key. A reputable auto locksmith will be able to resolve the issue within minutes. They can program your car and cut a fresh, functioning key for you. Click here to locate a locksmith near you.
Electronic chip that is malfunctioning
The electronic chip in the Peugeot 308 key fob is a critical function in the remote control system. If it gets damaged, your car may not start or you might get a message saying "anti-theft active". In this situation the only option is to replace the key. Professional auto locksmiths can provide this service within the shortest possible time.
The chip inside the chip of your Peugeot 308 key fob can be damaged due to water damage, sweat, dirt or other reasons. If your Peugeot 308 key fob is exposed to soapy water, it is recommended to clean it immediately. You can make use of a towel and isopropyl alcohol to clean the electronic component. After that, you should allow the battery to dry completely.
Sometimes the key fob may stop working because of radio interference. This could be caused by other devices that operate at the same frequency as your Peugeot key fob. It can also be caused by weather conditions or objects around the vehicle. It is recommended that you visit a Peugeot dealer if you have this issue.
The Peugeot 207/308 Key Fob is very delicate and requires special attention. It is important not to drop or throw the key fob. If you lose something, try to find it as soon as possible. You can reset the on-board computer by disconnecting the battery for a few minutes. Be sure to disconnect the negative cable first before connecting the positive.